Tuesday, September 29, 2009

getting a command prompt using ssh to dns-323 funplug

Oddly, the answer is this:


That's what you type into the bizarre ash promptless window to get a prompt

If you don't know the context of this post, after you install funplug on your dns-323, this is after you setup your NAS for SSH access.

  1. start a command window
  2. telnet your DNS-323 ip address
  3. /ffp/start/sshd start

No comments:

dead pi

Well, I guess it has to happen at some point. the home automation raspberry pi has died. Much to do with the stupid Strontium mini SD card. ...